Go back –> Atheros Linux wireless drivers
About wil6210
wil6210 is the Wilocity 60 GHz 802.11ad driver.
What works
Only monitor mode can be used right now.
- sniffer. Due to hardware limitation it captures either only CP (control PHY) or DP (data PHY) frames
- BSS between 2 peers. Both AP and managed modes supported. Single peer is hardware limitation. Iperf gives slightly above 1gbps
TODO
- P2P and FST flows
- after disconnect, upon 2-nd connect hardware goes crazy
- MSI interrupt
- various offloads
Status
A slew of initial 802.11ad patches have been posted. The drivers needs quite a bit of work before it gets posted for inclusion upstream but for those who have hardware and want to test the driver out in monitor mode you can use this release:
http://www.orbit-lab.org/kernel/compat-wireless/2012/06/compat-wireless-2012-06-29-pc.tar.bz2
You will need a kernel >= 2.6.30 given that the driver relies on PCI MSI being supported by your kernel. Ths release can be used on any kernel >= 2.6.30.
Firmware
We need to get this publicly available...
Subscribe to this page!
You should subscribe to this page so you can get e-mail updates on changes and news for ath9k automatically. You'll get an e-mail as soon as this page gets updated.